Agilent Technologies Agilent 3499A

117
Chapter 5 Remote Interface Reference
3499A/B/C SCPI Alphabetical Reference
4
5
Command Summary
DIAGnostic
:DISPlay[:INFOrmation] <message>
Display message on front panel. See page 158.
:DISPlay:STATe <0|1|OFF|ON>
Disable/Enable display. See page 158.
:DISPlay:STATe?
Query state of display. See page 158.
:MONitor <slot>|<channel>|<port>|-1
Monitor a slot or a channel/port, or disable a monitor. See page 159.
:MONitor?
Query which slot or channel is monitored. See page 159.
[:RELay]:CYCLes? <channel_list>
Query relay cycle of the specified channels. See page 155.
[:RELay]:CYCLes:MAX? <slot>
Query maximum cycles of channel relays. See page 155.
[:RELay]:CYCLes:CLEar <channel_list>
Clear channel relay cycle. See page 155.
SPEEK? <slot>,<register>
Read a 8-bit data from the <register> specified. See page 131.
SPOKE <slot>,<register>,<data>
Write a 8-bit data to the <register> specified. See page 131.
INITiate
Start a scanning cycle. See page 138.
[ROUTe:]
[CHANnel:]DELay <seconds>,<channel_list>|ALL
Set channel-to-channel interval. See page 136.
[CHANnel:]DELay? <channel_list>
Query channel-to-channel interval. See page 136.
CLOSe <channel_list>
Close one or multiple channels. See page 127.
CLOSe? <channel_list>
Queries relay closed state. See page 127.
CLOSe:STATe?
Query all closed relays. See page 128.
CPAir <slot1>,<slot2>|-1
Pair two cards of the same type or cancel a pair. See page 129.