16
Chapter 1 Quick Start
To Prepare the Instrument for Use
1
When shipped from the factory, the SCPI mode and the GPIB interface
address of “9” are used. Slot 0 refers to the built-in controller board of the
switch/control system.
If the Instrument Does Not Turn On
1. Verify that the power cord is firmly plugged into the power receptacle
on the rear panel of the 3499A/B/C.
2. Make sure that the power source the 3499A/B/C is plugged into is
energized.
3. Verify that the 3499A/B/C is turned on.
Note If the 3499A/B/C DOES NOT turn on after you perform the above
procedure, contact your nearest Agilent Service Center (see page 8).
To Next Page
Loading...