168
Chapter 6 Error Messages
Execution Errors
6
-121 Invalid character in number
An invalid character was found in the number specified for a parameter.
Example: TRIG:TIMER 12..34
-123 Exponent too large
A numeric parameter was found whose exponent was large than 32,000.
-124 Too many digits
A numeric parameter was found whose mantissa contained more than
255 digits, excluding leading zeros.
-128 Numeric data not allowed
The wrong parameter type was found in the command string. You may
have specified a number where a string or expression was expected, or
vice versa.
Examples:
DISP:TEXT 5.0 or ROUT:CLOSE 101
-131 Invalid suffix
A suffix was incorrectly specified for a numeric parameter. You may have
misspelled the suffix.
-134 Suffix too long
A header suffix is the number that can be appended to the end of some
command headers. This error is generated if the header suffix contains
more than 12 characters.
-138 Suffix not allowed
A suffix was received following a numeric parameter. You may have
misspelled the suffix.
-148 Character data not allowed
A discrete parameter was received but a character string or a numeric
parameter was expected. Check the list of parameters to verify that you
have used a valid parameter type.
Examples: ROUTE:CLOSE CH101 or DIAG:DISP TEXT123
(the string must be enclosed in quotes)
-151 Invalid string data
An invalid character string was received. Check to see if you have
enclosed the character string in quotation marks and verify that the
string contains valid ASCII characters.
Example: DIAG:DISP ’TESTING (the ending quote is missing)
-158 String data not allowed
A character string was received but is not allowed for this command.
Check the list of parameters to verify that you have used a valid
parameter type.
To Next Page
Loading...
Need help?
General