45
Chapter 2 Front-Panel Operation
To Configure the Power-on State
4
2
6. Turn the knob to select the desired memory location (i.e., 08).
7. Press Enter to accept the stored state and return to the first level
menu. More information about storing states is given on page 106 of
this manual.
8. Press the Menu key again to exit the Menu menu. The CONFIG
annunciator turns off.
Note If the instrument is set to power on to a previously stored setup that is
no longer valid, it will automatically power on to the reset state and
“RECALL FAILED” will be displayed.
POWER ON 08
POWER ON SET
To Next Page
Loading...
Need help?
General