Menu Reference 3
E4418B Power Meter User’s Guide 131
■
Press this softkey to modify the highlighted parameter, which is
either a frequency, calibration factor, offset or table name. A
pop- up window displays the parameter. Use the , , ,
and keys to change the parameter value. To confirm your
choice, press .
■
Press this softkey to insert a new table entry. You are prompted to
enter the frequency and calibration factor or offset. The entry is
inserted in ascending frequency order.
■
Press this softkey to delete a table entry. If you delete the
frequency, the corresponding calibration factor or offset is also
removed and vice versa.
■
Press this softkey to return to the measurement screen. The
softkeys from the first level of the “System/Inputs” menu are
displayed.
•
Press this softkey to access a menu and screen which allows you to select
and edit frequency dependent offset tables. Use the
and keys
to scroll through the displayed frequency dependent offset tables.
■
Press this softkey to access a menu and screen which allows you to
modify, add and remove frequency, calibration factors and offsets
from the currently selected table and modify the table name. Use the
, , , and keys to move between the name,
frequency, calibration factors and offsets. Press , , or
as follows:
■
Press this softkey to modify the highlighted parameter, which is
either a frequency, calibration factor, offset or table name. A
pop- up window displays the parameter. Use the , , ,
and keys to change the parameter value. To confirm your
choice, press .
To Next Page
Loading...
