Agilent Technologies ENA Series

Chapter 6 165
Replacement Procedure
Required Tools
6. Replacement Procedure
Required Tools
The following tools are required for repair of E5061A/E5062A.
Table 6-1 Required Tools
Assembly TORX screwdriver flat edge
screwdriver
torque
screwdriver
TORX T10
pozidriv
screwdriver
hex key open wrench open torque
wrench
T8 T10 T15 T20 1.5 mm 9/16 in. 5/8 in. 5/16 in.
Outer Cover 
Front Panel  
HDD  
FDD 
Power Supply  
Handler I/O 
Digital Mother Board 
Source Board   
Receiver Board   
Fan   
Analog Motherboard   
PCI DSP Card  
GPIB Card 
Front Keyboard   
Inverter  
LCD  
LCD Backlight  