Agilent Technologies ENA Series

220 Appendix C
Firmware Update
Firmware Update
Firmware Update
Required Equipment
• E5061A or E5062A (with keyboard and mouse).
• Four blank floppy disks (DOS format).
How to make E5061A/E5062A Firmware Installation Disk
The following is the procedure to make the E5061A/E5062A Firmware Installation Disk.
Step 1. Copy the following files from Agilent Technologies web site to the four floppy disks using
your computer’s FDD.
• disk1(1 of 4)-- e5062.msi, e506201.cab
• disk2(2 of 4)-- e506202.cab
• disk3(3 of 4)-- e506203.cab
• disk4(4 of 4)-- e506204.cab
Step 2. Assign the Label name as follows using the properties of your computer’s Windows
Explorer as shown in Figure C-1.
• DISK_1 (for disk1)
• DISK_2 (for disk2)
• DISK_3 (for disk3)
• DISK_4 (for disk4)
Figure C-1 Windows Explorer (example)
1. Insert the disk1(1 of 4) into the FDD of your computer.
2. On the Windows Explorer, click 3 1/2 Floppy [A:] and confirm the files.
3. Right click on 3 1/2 Floppy [A:], then click Properties. The Properties dialog box
appears.
4. Enter the Label name in the Label box of properties dialog box (General) for the disk1