84 Chapter 3
Adjustment
Required Adjustment after Replacing Assembly
Required equipment for frequency reference adjustment
Synthesizer Gain Adjustment
The purpose of this procedure is to adjust the synthesizer gain of the source board.
Required equipment for the synthesizer gain adjustment
Local Output Power Adjustment
The purpose of this procedure is to adjust the local output power of the source board.
Required equipment for the local output power adjustment
Source Output Power Adjustment
The purpose of this procedure is to adjust the output level from the source board.
Description Recommended Model
Frequency Counter Agilent 53131A Opt. 010
BNC(m)-BNC(m) Cable, 122
cm
Agilent p/n 8120-1840
Description Recommended Model
None None
Description Recommended Model
None None
To Next Page
Loading...
