Maintenance
M3860A and M3861A H
EARTSTREAM FR2 Defibrillator 4-15
4
Operator’s Checklist
The checklist on the following page is for your reference. You may want to
photocopy it or use it as the basis for creating your own checklist.
Inspect the H
EARTSTREAM FR2 as suggested in the maintenance schedule
above, or as specified by your Medical Director. When you use the Checklist,
fill in the scheduled frequency intervals you will be using for your
maintenance inspections. Check off each requirement as you complete it,
make a note of any problems you found or corrective action you took, and
sign the form.
• Check the data card if one has been used.
If the data card has been used to record incident data:
• Remove and replace it with a blank data card.
• Deliver the recorded data card to appropriate personnel according to your
local guidelines and medical protocol.
• Check the outside of the HEARTSTREAM FR2 and the connector socket for signs of
dirt or contamination.
If the H
EARTSTREAM FR2 is dirty or contaminated:
• Clean it according to the guidelines provided in this User’s Guide.
• Check the connector socket to make sure that defibrillation pads are disconnected
from the H
EARTSTREAM FR2 when it is not in use.
• Check to make sure the data card tray is installed, even if a data card is not being
used.
Daily Monthly
After
Each
Use
TAS K/ R ESPON SE
To Next Page
Loading...
Need help?
General
