3 Installing Intuvo 9000 GC Columns
To Replace an Intuvo GC Column
5977B Series MSD Operating Manual 61
7 Using the Intuvo torque driver, rotate all four column clamps off the column's
retainer ring. (See Figure 11.)
8 Unplug the column SmartID key from the lower USB port.
9 Using the Intuvo torque driver, remove the two compression bolts that seal
the column's click and run connectors to the bus and store for later use.
10 Remove and store the column for later use in accordance with the column
manufacturer's recommendations.
Figure 11. 9000 GC column and related parts
SmartID key
Column clamps
Retainer ring
Compression
bolts
Click and run
connectors
To Next Page
Loading...
Need help?
General
