Installation 2
Step 4. Connect the instrument to a power supply
Agilent SureCycler 8800 Setup and User’s Guide 17
Step 4. Connect the instrument to a power supply
The instrument must be connected to a grounded AC outlet.
1 Plug the instrument’s power cord into the power connector at the rear
of the
instrument.
2 Connect the other side of the cable to the outlet.
Step 5. Connect optional devices
If desired, you can connect an optional USB device (such as a keyboard
mouse or memory stick) to the instrument via the USB ports on the front
of the instrument.
1 Plug the USB cable of the device into either USB port on the
instru
ment.
Step 6. Turn on the instrument
1 Press the power button located near the bottom left corner on the front
of the instrument.
You can turn off the instrument any time. You do not need to close
the
software before you turn off the instrument.
Step 7. Connect the cycler to a network (optional)
1 Plug one end of an ethernet cable into the ethernet port on the back of
the instrument.
2 Plug the other end of the cable into a network port.
To Next Page
Loading...
Need help?
General
