ahlmann AS 210 - Engine Oil Change; Changing Oil in the Hydraulic System; Anti-Freezing Agent for the Windshield Washer System; Driving the Loader on Public Roads

S220/S221/S230/S231/Z2005-4
5 Operation
5.2.2.2 Engine oil change
See the operating instructions for the engine and for the
machine (section 8.2.6).
5.2.2.3 Changing oil in the hydraulic system
CAUTION
The viscosity of the hydraulic oil changes according
to the temperature; therefore, the ambient
temperature in the location where the machine
will be used determines what viscosity class
(SAE class) must be chosen. If the hydraulic oil
used matches the expected ambient temperature,
optimum operating conditions can be attained.
Therefore, use hydraulic oil of an appropriate
grade if required.
See section 8.2.9 for the oil change procedure
required for the hydraulic system.
5.2.2.4 Anti-freezing agent for the
windshield washer system
CAUTION
If the temperature is expected to drop below 0° C,
add a sufficient amount of anti-freezing agent to
the water in the windshield washer system (5-3/
arrow) to prevent it from icing up.
Heed the instructions provided by the manufacturer
for the mixture ratio.
5.2.3 Driving the loader on public roads
CAUTION
- Driving on public roads is only permitted with
an empty standard or multi-purpose bucket
and only with bucket protection.
- When the road lights (which are used solely
to light up the road) are switched on, the
highest permissible speed is 30 km/h.
- According to § 52 (4) No. 1 of the German
Motor Vehicle Construction and Use
Regulations, the warning beacon (optional
equipment) may be switched on only if the
loader is marked by red and white warning
stripes.
- A warning triangle and a first-aid kit must be
provided in the loader.
The driver of the loader must possess a valid driver’s
license.
The driver must carry his driver’s license (original) and the
operating permit (original) with him.
Figure 5-3