ahlmann AS 210 - Decommissioning the Loader; Parking the Loader; Switching off the Diesel Engine; Switching off the Heater and Ventilation System

S220/S221/S230/S231/Z2005-8
5 Operation
5.3 Decommissioning the loader
5.3.1 Parking the loader
(1) Stop the loader on solid ground; if possible, not on a
slope.
(2) Apply the parking brake (4-9/7).
(3) Place the bucket or the attachment on the ground.
(4) Set the drive switch (4-9/5) to “0”.
DANGER
If parking on a gradient cannot be avoided, wheel
chocks must be used and placed on the sloping
side of the front axle wheels in addition to
applying the parking brake.
5.3.2 Switching off the diesel engine
CAUTION
If the diesel engine is very hot or has been
subjected to heavy loads, let the engine idle for a
short time before switching it off.
Turn the ignition key to the left to position „0“ (5-1) and
remove the key.
NOTE
In position “P”, the parking light and the dashboard
illumination remain switched on.
5.3.3 Switching off the heater and
ventilation system
(1) Shut off the hot air supply (5-6/1).
(2) Turn the rotary switch (5-6/2) for the blower to position “0”.
5.3.4 Leaving the loader
(1) Lock the ball block valve for the working and auxiliary
hydraulics (4-8/2).
(2) Remove the main battery switch (8-21/2).
NOTE
If the loader is to remain shut down for a long
period of time, carry out the duties in Chapter 3
(Protection Against Theft).
(3) Remove the ignition key and lock the doors.
i
i