S220/S221/S230/S231/Z2005-10
5 Operation
(2) Height adjustment:
The height can be adjusted in several steps.
Lift the driver’s seat to the desired height until it can be
heard to engage. The seat returns to the lowest position
when it is lifted over the topmost position (stop) (5-12).
(3) Armrest inclination:
Turn the handwheel (5-13/arrow) to adjust the armrest in
longitudinal direction.
(4) Armrests:
If desired, you can swing the armrests to the rear and adjust
their height.
To adjust the armrest height, remove the round cap (5-14/
arrow) in the covering.
Loosen the hex nut (wrench size 13 mm), set the armrest
as desired and tighten the nut again. Push the removed cap
onto the nut again.
Figure 5-13
Figure 5-12
Figure 5-14
To Next Page
Loading...