3
Chapter3 Installation 101
Step 3: Connect TrusGuard to Network
Connect TrusGuard to upper/lower router/switch.
Select the cable that fits the upper/lower router/switch interface specification.
Check the TrusGuard’s UTP port status.
• The green LED on the left of the port will turn on if properly connected. If not, the light will not
turn on.
• When the connection speed is 10 Mbps or 100 Mbps, the orange LED on the right of the port
will turn on. If not, it will flicker.
• When the connection speed is 1 Gbps, the green LED on the right of the port will turn on. If not,
it will flicker
Check TrusGuard’s SPF port status.
• The optical cable is a pair of RX/TX cables. Check whether connected in router/switch.
To Next Page
Loading...