2.2.2.3 Power ON-OFF Button
The module is immediately powered on, if the DC Power is available (i.e. if the DC
power plug is connected to the DC Back panel socket).
The module power is switched ON/OFF using the push-button at the Back panel (see
figure from Back panel).
Power-ON
To power up the module press the button.
Power-OFF
For power down the module press the button again.
If the button is pressed for approximately 3sec, a power down is forced without
shutdown cycle of the OS. This is not recommended and should only be done in case of
a hang up of the module.
Further help on how to get the module ANET429 started and all the tools provided to
work with the module ANET429 can be found in chapter “Getting started” in this manual.
To Next Page
Loading...
