Airzone RADIANT365 - Page 32

32
2 pipes / 3/ 4 pipes
Mode Demand
Control Relays
MODE_Y
MODE_W
AIR_Y
RAD_Y
AIR_W
RAD_W
Stop
Off
--
--
--
--
--
--
Cooling
mode
Air
ON
--
ON
--
--
--
Radiant
ON
--
--
ON
--
--
Off
ON
--
--
--
--
--
Heating
mode
Air
--
ON
--
--
ON
--
Radiant
--
ON
--
--
--
ON
Off
--
ON
--
--
--
--
Heating
mode
On
ON -- -- -- -- --
Off
Ventilation
On
-- -- -- -- -- --
Off
RadianT
Mode Demand
Control Relays
MODE_Y
MODE_W
AIR_Y
RAD_Y
AIR_W
RAD_W
Stop
Off
--
--
--
--
--
--
Cooling
mode
Radiant
ON
--
--
ON
--
--
Off
--
--
--
--
--
--
Heating
mode
Radiant
--
ON
--
--
--
ON
Off
--
--
--
--
--
--
Dew warning
active
On
ON
--
ON
--
--
--
Off
ON
--
ON
--
--
--
For Acuazone and Innobus Pro 32 systems versions v.4.4.1 or higher: In any configuration of the Acuazone central
operating logic, zones with air flow stage configured as (Direct Expansion) DX will not generate air demand in the production
control board. Remember that in both zoned or mixed configurations, when the air flow stage of a zoned area is modified, the
same configuration will apply to the rest of the zones in the group.
Important: The following combinations will not generate air demand in the production control board:
- Communication gateway (AZX6QADAPTxxx / AZX6QADAPT3xxx / AZX6GTC xxx / AZX6ELECTROMEC) in Flexa 3.0,
Innobus Pro6, Acuazone and Innobus Pro32 (v.4.4.0 or lower) main control boards.
- Gateway modules (AZDI6MCIFR [C/R] / AZDI6MCxxx [C/R] / AZDI6ZMOxxx [C/R]) in Acuazone e Innobus Pro32 (v.4.4.0
or lower) systems (when configured as a zoning system or mixed system).
Important: To guarantee the optimization of the production temperature of the aerothermal units, these device combinations
do not generate demand to the production control board:
- Zoning module for Electrical Heating Element (AZDI6MZSRE [C/R]) in Acuazone and Innobus Pro32 systems regardless
of the Main control board configuration.