FS2 v2.1r1 www.aja.com
31
5. Turn SELECT to advance to 2.3 Subnet Mask. Use the SELECT and ADJUST knobs as in
the previous step to set the desired subnet mask.
6. Turn SE
LECT to advance to 2.4 Default Gateway. Use the SELECT and ADJUST knobs as
in the previous step to set the desired gateway address.
7. Run a browser on the computer and type in the IP addr
ess you set for the FS2. You
should now see the FS2’s Status screen.
When you can access the FS2 screens, turn to “Browser Remote Control” on page 85 for
details about configuring the FS2 using
a browser.
To Next Page
Loading...
