be installed with digital forehead temperature detector therefore
you can are required to set the mode properly according to your
application.
Mask Detection: select “Enable” or” Disable” to turn on or turn off
the mask detection. When enabled, the device will check if the
visitor is wearing a mask or not while reminding the visitor with
the announcement “Please wear a mask” while visitors wearing
mask will be prompted either “Keep face in the frame” or “Keep
wrist close to the sensor” depending on the mode that is selected.
Warning alarm will be triggered when the body temperature
measured is detected higher than the defined normal body
temperature.
Normal Body Temperature: set the body temperature to the
predefined body temperature as the measuring basis in either
Fahrenheit or Celsius. For example if you set the temperature 37.3
degree Celsius as the normal temperature, then any body
temperature measured higher than 37.3 degree Celsius will be
deemed as abnormal temperature, while the temperature lower
than 34 degree Celsius will be deemed as low body temperature.
To Next Page
Loading...
Need help?
General
