AKUVOX SMART INTERCOM www.akuvox.com
1. Click Device > LCD > Standby Interface Display
2. Set up parameters properly according to your need.
3. Click Submit tab for the validation and Cancel tab for the
cancellation.
Parameter Set-up
ScreenSaver Mode: tick the check box to enable the screen saver
function.
Sleep: set the screen saver start time range from “5” seconds to
“ 30” minutes For example, if you set it as “ 15 seconds” then the
device will go into screen saver mode in 15 second when when
there is no operation on the device or no one is detected
approaching
To Next Page
Loading...
