Installing Your Switch
Page 34 7210 SAS-D Installation Guide
Desktop or Shelf Mounting
Step 1 Attach the four adhesive feet to the bottom of the first switch. See Figure 16.
Figure 16: Attaching the Adhesive Feet
Step 2 Set the device on a flat surface near an external power source, making sure
there are at least three inches of space on the front, sides, rear and top for
proper air flow.
Step 3 If you are installing a single switch, proceed to "Grounding the Chassis" on
page 36.
Step 4 If you are installing multiple switches, attach four adhesive feet to each
switch. Place each device squarely on top of the one below, in any order.
To Next Page
Loading...
