Initializing the System and Downloading Software
Page 54 7210 SAS-D Installation Guide
Booting a 7210 SAS-D using the image on Flash (with the image shipped by
factory)
You will need the following:
• A PC with a serial port and Hyperterminal
• Cable that connects the console port of SAS-D to the serial port of PC
Connect the 7210's console port to serial port of the PC and then power on the 7210
SAS-D. The system will start booting up with messages on the console similar to those
shown below. Follow the procedure given below to boot the system with the image on
the flash.
Resetting...OK
Alcatel-Lucent 7210 Boot ROM. Copyright 2009-2011 Alcatel-Lucent.
All rights reserved. All use is subject to applicable license agreements.
Testing ROM load area...done
Relocating code...Jumping to RAM
Performing second stage RAM test....passed
Board Serial Number is 'NS1111C0115'
Bootlog started for Version A-V-3.0.B5-85
Build V-3.0.B5-85 bootrom/mpc 7xxx
Built on Wed Apr 20 13:52:05 IST 2011 by builder in /builder/3.0B5/panos/
main
?Attempting to load from file cf1:/boot.tim
Version L-3.0.B5-85, Wed Apr 20 14:13:38 IST 2011 by builder in /builder/
3.0B5/panos/main
text:(4782384-->20108848) + data:(1084015-->3891872)
Starting at 0xb000000...
PCIe: Port 0 Link UP
Total Memory: 512MB Chassis Type: sas Card Type: badami_7210
TiMOS-L-3.0.B5-85 boot/mpc ALCATEL SAS-D 6F4T 7210 Copyright (c) 2000-2011
Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:13:38 IST 2011 by builder in /builder/3.0B5/panos/
main
To Next Page
Loading...
Need help?
General
