Initializing the System and Downloading Software
Page 58 7210 SAS-D Installation Guide
The default username and password are admin. Log into the 7210 SAS-D.
To establish either console connection or Telnet connection to the router after
successful boot, please see "Establishing Switch Connections" on page 69
Booting a 7210 SAS-D from the Network
For network load user can use one of the front panel ports (refered to as uplinkA and
uplinkB in the display output shown below) to boot the 7210 from the network. The
example below shows how to boot the device with the out-of-band management port
and without it using the manual boot process. For more information on how the boot
process works in 7210 SAS-D, please refer to the System Basics guide. Figure 23 on
page 58shows the network diagram used in the example below.
Additionally, you may want to store the TiMOS image on the internal flash if you want
to boot from the flash later.
Figure 23: 7210 SAS-D Boot Process
Note: The SYS LED will be Green when the device has successfully completed the boot
process and is running normally.
OSSG552
FTP
Server
IP Address:
10.10.170.22/24
Port: 7
IP Address: 10.135.4.172/24
Gateway: 10.135.4.1
Console Cable
SAS-D
To Next Page
Loading...
