Configuring the 7210 SAS-D
7210 SAS-D Installation Guide Page 71
MAC addresses are listed on a small label on the chassis. The MAC address also
displays in the
show router arp command output.
The 7210 SAS-D must have a management IP address. The IP address is manually
configured.
Running Telnet
Once the IP parameters are configured, you can access the CLI command line with a
Telnet connection. To establish a Telnet connection, run a Telnet program and issue
the Telnet command, followed by the IP address:
The following displays an example of a Telnet login:
C:\>telnet 10.10.10.25
Login: admin
Password: <enter password for user admin>
ALA-1#
To Next Page
Loading...
