Installing Your Switch
Page 36 7210 SAS-D Installation Guide
Grounding the Chassis
Before powering on the switch, ground the switch to earth as described below.
Step 1 Ensure that the rack on which the switch is to be mounted is properly
grounded.
Step 2 Ensure that you have made a suitable electrical connection to the grounding
point on the rack. Ensure that no paint or isolating surface treatment is present
on the grounding point.
Step 3 Disconnect all power cables to the switch.
Step 4 Ground per local electrical codes.
Step 5 Attach the grounding wire to the ground points on the rack.
CAUTION
The earth connection must not be removed unless all supply connections have been disconnected.
To Next Page
Loading...
