Alcatel-Lucent 7210 SAS M - Configuring BOF Parameters

Configuring BOF Parameters
Page 114 7210 SAS M, X Basic System Configuration Guide
Configuring BOF Parameters
The following output displays a BOF configuration:
A:7210>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@135.254.170.29//import/panos_builds/nightly/2.0
/S80/MTU-sultan/
primary-config tftp://10.135.25.100/MTU/mtu3DGP.cfg
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
===============================================================================
A:7210>show#