Alcatel-Lucent 7210 SAS M - Deleting BOF Parameters

Service Management Tasks
Page 118 7210 SAS M, X Basic System Configuration Guide
Deleting BOF Parameters
You can delete specific BOF parameters. The no form of these commands removes the parameter
from configuration. The changes remain in effect only during the current power cycle unless a
save command is executed. Changes are lost if the system is powered down or the router is
rebooted without saving.
Deleting the BOF file and then rebooting, causes the system to enter auto mode.
Use the following CLI syntax to save and remove BOF configuration parameters:
CLI Syntax: bof# save [cflash-id]
Example
: A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
CLI Syntax:*A:7210>bof#
no console-speed
no dns-domain
no eth-mgmt-address
no eth-mgmt-autoneg
no eth-mgmt-disable
eth-mgmt-duplex
no eth-mgmt-route
eth-mgmt-speed
persist
no ping-address
no primary-config
no primary-dns
no primary-image
save
no secondary-config
no secondary-dns
no secondary-image
no tertiary-config
no tertiary-dns
no tertiary-image
no uplinkA-address
no uplinkA-port
no uplinkA-route
no uplinkA-vlan
no uplinkB-address
no uplinkB-port
no uplinkB-route
no uplinkB-vlan
wait