Alcatel-Lucent 7210 SAS M - BOF Command Reference

Boot Option Files
7210 SAS M, X Basic System Configuration Guide Page 121
BOF Command Reference
Command Hierarchies
Configuration Commands
bof
— console-speed baud-rate
—no console-speed
— dns-domain dns-name
—no dns-domain
— [no] eth-mgmt-address ip-prefix/ip-prefix-length
— [no] eth-mgmt-autoneg
— [no][no] eth-mgmt-disabled
— eth-mgmt-duplex {full | half}
— [no] eth-mgmt-route <ip-prefix/ip-prefix-length> next-hop <ip-address>
— eth-mgmt-speed speed
— persist {on | off}
— ping-address ip-address
—no ping-address
— primary-config file-url
—no primary-config
— primary-dns ip-address
—no primary-dns
— primary-image file-url
—no primary-image
— save [cflash-id ]
— secondary-config file-url
—no secondary-config
— [no] secondary-dns ip-address
— secondary-image file-url
—no secondary-image
— tertiary-config file-url
—no tertiary-config
— tertiary-dns ip-address
—no tertiary-dns
— tertiary-image file-url
—no tertiary-image
— uplink-mode {access-uplink|network} (Not applicable on 7210 SAS-X)
— wait seconds
— uplinkA-address ip-address/mask
—no uplinkA-address
— uplinkA-port port-id
—no uplinkA-port
— [no] uplinkA-route <ip-address/mask> next-hop <ip-address>
— uplinkA-vlan 0..4094
—no uplinkA-vlan
— uplinkB-address ip-address/mask
—no uplinkB-address
— uplinkB-port port-id
—no uplinkB-port