Alcatel-Lucent 7210 SAS M - Table 24: Show System SNTP Output Fields

System Management
7210 SAS M, X Basic System Configuration Guide Page 309
Sample Output
A:pc-40>config>system>time>ntp# show system ntp
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
===============================================================================
A:pc-40>config>system>time>ntp# show system ntp all
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
===============================================================================
NTP Active Associations
===============================================================================
State Remote Reference ID St Type Auth Poll R Offset
-------------------------------------------------------------------------------
reject 192.168.15.221 192.168.14.50 2 srvr none 64 y 0.901
chosen 192.168.15.221 192.168.14.50 2 mclnt none 64 y 1.101
===============================================================================
A:pc-40>config>system>time>ntp#
sntp
Syntax sntp
Context show>system
Description This command displays SNTP protocol configuration and state.
Output Show SNTP Output — The following table describes SNTP output fields.
Table 24: Show System SNTP Output Fields
Label Description
SNTP Server
The SNTP server address for SNTP unicast client mode.
Version
The SNTP version number, expressed as an integer.