Alcatel-Lucent 7210 SAS M - Page 308

System Commands
Page 308 7210 SAS M, X Basic System Configuration Guide
Peer Codes:
ACST — The association belongs to any cast server.
AUTH — Server authentication failed. Please wait while the associa-
tion is restarted.
AUTO — Autokey sequence failed. Please wait while the association
is restarted.
BCST — The association belongs to a broadcast server.
CRPT — Cryptographic authentication or identification failed. The
details should be in the system log file or the cryptostats statistics file,
if configured. No further messages will be sent to the server.
DENY — Access denied by remote server. No further messages will
be sent to the server.
DROP — Lost peer in symmetric mode. Please wait while the associa-
tion is restarted.
RSTR — Access denied due to local policy. No further messages will
be sent to the server.
INIT — The association has not yet synchronized for the first time.
MCST — The association belongs to a manycast server.
NKEY — No key found. Either the key was never installed or is not
trusted.
RATE — Rate exceeded. The server has temporarily denied access
because the client exceeded the rate threshold.
RMOT — The association from a remote host running ntpdc has had
unauthorized attempted access.
STEP — A step change in system time has occurred, but the associa-
tion has not yet resynchronized.
System Codes
INIT — The system clock has not yet synchronized for the first time.
STEP — A step change in system time has occurred, but the system
clock has not yet resynchronized.
St
Stratum level of this node.
Auth
yes — Authentication is enabled.
no — Authentication is disabled.
Poll
Polling interval in seconds.
R
Yes — The NTP peer or server has been reached at least once in the
last 8 polls.
No — The NTP peer or server has not been reached at least once in
the last 8 polls.
Offset
The time between the local and remote UTC time, in milliseconds.
Label Description (Continued)