Alcatel-Lucent 7210 SAS M Basic System Configuration Guide

System Management
7210 SAS M, X Basic System Configuration Guide Page 179
Location
Use the location command to specify the system location of the device. For example, enter the
city, building address, floor, room number, etc., where the router is located.
Use the following CLI syntax to configure the location:
CLI Syntax: config>system
location location
Example
: config>system# location “Bldg.1-floor 2-Room 201”
CLLI Code
The Common Language Location Code (CLLI code) is an 11-character standardized geographic
identifier that is used to uniquely identify the geographic location of a router.
Use the following CLI command syntax to define the CLLI code:
CLI Syntax: config>system
clli-code
clli-code
Example: config>system# clli-code abcdefg1234

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English