Common Configuration Tasks
Page 200 7210 SAS M, X Basic System Configuration Guide
Ingress
This command is an enhancement for specific ingress policies including filter lists and QoS
policies. Use this command to create time-range based associations of previously created filter
lists and QoSpolicies. Multiple policies may be included and each must be assigned a different
priority; in case time-ranges overlap, the priority will be used to determine the prevailing policy.
Only a single reference to a policy may be included without a time-range. To configure a daily
time-range across midnight, use a combination of two entries. An entry that starts at hour zero will
take over from an entry that ends at hour 24.
CLI Syntax: config>system
cron
tod-suite tod-suite-name create
ingress
filter ip ip-filter-id [time-range time-range-name]
[priority priority]
filter mac mac-filter-id[time-range time-range-
name] [priority priority]
qos policy-id [time-range time-range-name] [priori-
ty priority]
Example
: config>cron>tod-suite$ ingress filter ip 100
config>cron>tod-suite$
The following command shows an ingress IP filter association with filter ID 100.
sim1>config>filter# ip-filter 100 create
A:sim1>config>filter>ip-filter$ entry 10 create
A:sim1>config>filter>ip-filter>entry$
...
A:sim1>config>cron>tod-suite# ingress filter ip 100
A:sim1>config>cron>tod-suite# info detail
----------------------------------------------
no description
ingress
filter ip 100
exit
----------------------------------------------
A:sim1>config>cron>tod-suite#
To Next Page
Loading...
Need help?
General
