System Information Commands
Page 232 7210 SAS M, X Basic System Configuration Guide
System Information Commands
boot-bad-exec
Syntax boot-bad-exec file-url
no boot-bad-exec
Context config>system
Description Use this command to configure a URL for a CLI script to exec following a failure of a boot-up
configuration. The command specifies a URL for the CLI scripts to be run following the completion
of the boot-up configuration. A URL must be specified or no action is taken.
The commands are persistent between router (re)boots and are included in the configuration saves
(admin>save).
Default no boot-bad-exec
Parameters file-url — Specifies the location and name of the CLI script file executed following failure of the
boot-up configuration file execution. When this parameter is not specified, no CLI script file is
executed.
Values file url: local-url | remote-url: 255 chars max
local-url: [cflash-id/][file-path]
remote-url: [{ftp://} login:pswd@remote-locn/][file-path]
remote-locn [ hostname | ipv4-address]
ipv4-address a.b.c.d
cflash-id: cf1:
Related
Commands
exec command on page 47 — This command executes the contents of a text file as if they were CLI
commands entered at the console.
boot-good-exec
Syntax boot-good-exec file-url
no boot-good-exec
Context config>system
Description Use this command to configure a URL for a CLI script to exec following the success of a boot-up
configuration.
Default no boot-good-exec
Parameters file-url — Specifies the location and name of the file executed following successful completion of the
boot-up configuration file execution. When this parameter is not specified, no CLI script file is
executed.
To Next Page
Loading...
