System Information Commands
Page 234 7210 SAS M, X Basic System Configuration Guide
xyz.cfg
xyz.cfg.1
xyz.cfg.2
xyz.cfg.3
xyz.cfg.4
xyz.cfg.5
xyz.ndx
Each persistent index file is updated at the same time as the associated configuration file. When the
index file is updated, then the save is performed to xyz.cfg and the index file is created as xyz.ndx.
Synchronization between the active and standby is performed for all configurations and their
associated persistent index files.
The no form of the command returns the configuration to the default value.
Default 5
Parameters count — The maximum number of backup revisions.
Values 1 — 9
contact
Syntax contact contact-name
no contact
Context config>system
Description This command creates a text string that identifies the contact name for the device.
Only one contact can be configured, if multiple contacts are configured the last one entered will
overwrite the previous entry.
The no form of the command reverts to default.
Default none — No contact name is configured.
Parameters contact-name — The contact name character string. The string can be up to 80 characters long. Any
printable, seven-bit ASCII characters can be used within the string. If the string contains special
characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
coordinates
Syntax coordinates coordinates
no coordinates
Context config>system
Description This command creates a text string that identifies the system coordinates for the device location. For
example, the command coordinates “37.390 -122.0550" is read as latitude 37.390 north and
longitude 122.0550 west.
To Next Page
Loading...
Need help?
General
