Alcatel-Lucent 7210 SAS M Basic System Configuration Guide

System Management
7210 SAS M, X Basic System Configuration Guide Page 255
server-address
Syntax server-address ip-address [version version-number] [normal | preferred]
[interval seconds]
no server-address
Context config>system>time>sntp
Description This command creates an SNTP server for unicast client mode.
Parameters ip-address — Specifies the IP address of the SNTP server.
version version-number — Specifies the SNTP version supported by this server.
Values 1 — 3
Default 3
normal | preferred — Specifies the preference value for this SNTP server. When more than one
time-server is configured, one server can have preference over others. The value for that server
should be set to preferred. Only one server in the table can be a preferred server.
Default normal
interval seconds — Specifies the frequency at which this server is queried.
Values 64 — 1024
Default 64

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English