Date and Time Commands
Page 270 7210 SAS M, X Basic System Configuration Guide
Syntax [no] scheduler-policy scheduler-policy-name [time-range time-range-name] [priority
priority]
Context config>cron>tod-suite>egress
config>cron>tod-suite>ingress
Description This command creates time-range based associations of previously created scheduler policies.
Multiple policies may be included and each must be assigned a different priority; in case time-ranges
overlap, the priority will be used to determine the prevailing policy. Only a single reference to a
policy may be included without a time-range.
Parameters scheduler-policy-name — Specifies a scheduler policy for this tod-suite.
Values Up to 32 characters
time-range time-range-name — Specifies the name for a time-range. If the time-range is not
populated the system will assume the assignment to mean “all times”. Only one entry without a
time-range is allowed for every type of policy. The system does not allow the user to specify
more than one policy and the same time-range and priority.
Values Up to 32 characters
priority priority — Specifies the time-range priority. Only one time-range assignment of the same
type and priority is allowed.
Values 1 — 10
To Next Page
Loading...
