Alcatel-Lucent 7210 SAS M - Page 316

System Commands
Page 316 7210 SAS M, X Basic System Configuration Guide
SAP 1/1/1:20
-------------------------------------------------------------------------------
tod-suite suite_sixteen : failed association for Customer MSS
-------------------------------------------------------------------------------
None
-------------------------------------------------------------------------------
Number of tod-suites failed/total : 1/1
===============================================================================
A:kerckhot_4#
Zooming in on one of the failed SAPs, the assignments of QoS and scheduler policies are shown as
not as intended:
A:kerckhot_4# show service id 1 sap 1/1/1:2
===============================================================================
Service Access Points(SAP)
===============================================================================
Service Id : 1
SAP : 1/1/1:2 Encap : q-tag
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Admin State : Up Oper State : Up
Flags : None
Last Status Change : 10/05/2006 18:11:34
Last Mgmt Change : 10/05/2006 22:27:48
Max Nbr of MAC Addr: No Limit Total MAC Addr : 0
Learned MAC Addr : 0 Static MAC Addr : 0
Admin MTU : 1518 Oper MTU : 1518
Ingress qos-policy : 1130 Egress qos-policy : 1130
Intend Ing qos-pol*: 1190 Intend Egr qos-po*: 1190
Shared Q plcy : n/a Multipoint shared : Disabled
Ingr IP Fltr-Id : n/a Egr IP Fltr-Id : n/a
Ingr Mac Fltr-Id : n/a Egr Mac Fltr-Id : n/a
tod-suite : suite_sixteen qinq-pbit-marking : both
Egr Agg Rate Limit : max
ARP Reply Agent : Unknown Host Conn Verify : Disabled
Mac Learning : Enabled Discard Unkwn Srce: Disabled
Mac Aging : Enabled Mac Pinning : Disabled
L2PT Termination : Disabled BPDU Translation : Disabled
Multi Svc Site : None
I. Sched Pol : SchedPolCust1
Intend I Sched Pol : SchedPolCust1_Night
E. Sched Pol : SchedPolCust1Egress
Intend E Sched Pol : SchedPolCust1Egress_Night
Acct. Pol : None Collect Stats : Disabled
Anti Spoofing : None Nbr Static Hosts : 0
===============================================================================
A:kerckhot_4#
If a time-range is specified for a filter entry, use the show filter command to view
results:
A:kerckhot_4# show filter ip 10
===============================================================================
IP Filter
===============================================================================
Filter Id : 10 Applied : No
Scope : Template Def. Action : Drop
Entries : 2
-------------------------------------------------------------------------------