Alcatel-Lucent 7210 SAS M Basic System Configuration Guide

System Commands
Page 330 7210 SAS M, X Basic System Configuration Guide
Debug Commands
sync-if-timing
Syntax sync-if-timing
Context debug
Description The context to debug synchronous interface timing references.
force-reference
Syntax force-reference {ref1 | ref2}
no force-reference
Context debug>sync-if-timing
Description This command allows an operator to force the system synchronous timing output to use a specific ref-
erence.
Note: This command should be used for testing and debugging purposes only. Once the system tim-
ing reference input has been forced, it will not revert back to another reference at anytime. The state
of this command is not persistent between system boots.
When the debug force-reference command is executed, the current system synchronous timing out-
put is immediately referenced from the specified reference input. If the specified input is not avail-
able (shutdown), or in a disqualified state, the timing output will enter the holdover state based on the
previous input reference.
Parameters ref1 — The clock will use the first timing reference.
ref2 — The clock will use the second timing reference.
system
Syntax [no] system
Context debug
Description This command displays system debug information.
ntp
Syntax [no] router router-name interface ip-int-name

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English