Alcatel-Lucent 7210 SAS M - Page 130

Command Reference
7210 SAS M, T, X, R6, R12, Mxp Interface Configuration Guide Page 125
LAG Commands
config
—LAG Commands
— [no] lag [lag-id]
— description long-description-string
—no description
— [no] dynamic-cost
— enable-dei
—no enable-dei
— encap-type {dot1q | null | qinq}
—no encap-type
— hold-time down hold-down-time
—no hold-time
— lacp [mode] [administrative-key admin-key][system-id system-id][system-priority
priority]
— lacp-xmit-interval {slow | fast}
—no lacp-xmit-interval
— [no] lacp-xmit-stdby
— mac ieee-address
—no mac
— mode access [uplink]
—no mode
— monitor-oper-group name
—no monitor-oper-group
—no oper-group
— oper-group name
— port port-id [port-id …up to 4 total] [priority priority] [sub-group sub-group-id]
—no port port-id [port-id …up to 4 total]
— port-threshold value [action {dynamic-cost | down}]
— port-threshold
— selection-criteria [{highest-count|highest-weight|best-port}] [slave-to-partner]
—no selection-criteria
— standby-signalling {lacp | power-off}
—no standby-signalling
— [no] shutdown
Multi-chassis Redundancy commands
config
— redundancy
— multi-chassis
—[no] peer ip-address [create]
— authentication-key [authentication-key | hash-key] [hash | hash2]
—no authentication-key
— description description-string
—no description
—[no] mc-lag
— hold-on-neighbor-failure multiplier
—no hold-on-neighbor-failure