Alcatel-Lucent 7705 SAR-A - SSH Connection; Figure 27 Management Port Connection

Establishing Router Management Connections
114 7705 SAR-A Chassis Installation Guide
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel (Figure 26) using an
RJ-45 CAT5e cable.
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
keyboard.
Step 4. At the router prompt, enter the login and password.
The default login is admin.
The default password is admin.
SSH Connection
SSH access provides the same options for user and administrator access as those available
through the console port or Telnet; however, SSH is more secure than Telnet. You can access
the router with an SSH connection from a PC or workstation connected to the network once
the following conditions are met:
• the router has successfully initialized
• the Management port (Figure 27) has been configured using the bof>address
command (see CLI Syntax)
CLI Syntax: bof
address ip-prefix/ip-prefix-length [primary |
secondary]
where:
address is an IPv4 or IPv6 address
Figure 27: Management Port Connection
Note: SSH connection attempts after a reboot may generate key warnings as the node
generates new SSH keys on each reboot. To avoid these key warnings, enable key
preservation using the config>system>security>ssh>preserve-key command.
7705 SAR-A
Mgmt
ToD Out
Lnk Act
Sync In
+Batt A
-Batt A
+Batt B
-Batt B
Console
812111097654B3B2B1B1A
Status
2A 3A 4A
ActLnk ActLnk ActLnk ActLnk
Stat Stat Stat Stat
2468
1357
Lnk Act Lnk Act Lnk Act Lnk Act
Stat Stat Stat Stat
T1/E1Ethernet
-48 VDC
23320
Management port