Alcatel-Lucent 7705 SAR-A - 7705 SAR-A Ports

7705 SAR-A Ports
124 7705 SAR-A Chassis Installation Guide
7705 SAR-A Ports
Figure 29 identifies the port connectors that are accessible on the 7705 SAR-A. The chassis
variant shown has T1/E1 ports.
Figure 29: 7705 SAR-A Port Connectors (Variant with T1/E1 Ports)
Management Port
The Mgmt (management) port supports half-duplex and full-duplex communication via
10/100 or autonegotiated Ethernet. The Mgmt port provides a channel to download software
and configuration files and to manage the system. This port has an RJ-45 connector on the
front panel. You must provide a shielded CAT5e Ethernet cable to connect to the port.
Shielded cable must be used to maintain EMC compliance.
Figure 30 shows the Management port pin numbers.
Figure 30: Management Port Pin Numbers
7705 SAR-A
Mgmt
ToD Out
Lnk Act
Sync In
+Batt A
-Batt A
+Batt B
-Batt B
Console
812111097654B3B2B1B1A
Status
2A 3A 4A
ActLnk ActLnk ActLnk ActLnk
Stat Stat Stat Stat
2468
1357
Lnk Act Lnk Act Lnk Act Lnk Act
Stat Stat Stat Stat
T1/E1Ethernet
-48 VDC
23321
Management
port
(4) Gigabit
Ethernet
RJ-45s
(4) FE
RJ45s
(4) Gigabit
Ethernet
SFPs
(4) Gigabit
Ethernet
SFPs
(8) T1/E1
RJ-45s
Console
port
ToD
Out port
Terminal
block
Synchronization
In
Status
LED
Pin 8 Pin 1
19593