Alcatel-Lucent 7705 SAR-A - Installing the Chassis in a Rack

Installing the Chassis in a Rack
70 7705 SAR-A Chassis Installation Guide
Installing the Chassis in a Rack
Rack-Mounting the Chassis
The 7705 SAR-A chassis is designed for installation in a 19-inch rack. The rack-mount
brackets are factory-installed. Figure 13 illustrates the installation of the chassis in a rack.
Table 14 lists the rack-mounting components.
Figure 13: Installing the 7705 SAR-A Chassis in a Rack
Note: Ensure that you observe the Dangers and Warnings that are described in Site
Preparation that pertain to grounding and installation before you install this equipment.
Warning:
• Non-conductive coatings (such as lacquer and enamel) must be removed from threads
and other contact surfaces to ensure electrical conductivity. Thread-forming screws with
paint piercing washers may be used for this purpose during installation.
• When rack-mounting the chassis in an equipment rack, do not stack one 7705 SAR-A
chassis or any other equipment directly on top of another 7705 SAR-A chassis, such
that the bottom chassis is supporting other devices. Each chassis must be secured in
the rack with the appropriate mounting apparatus.
23323
7705 SAR-A
Mgmt
ToD Out
Lnk
Act
Sync
In
+Batt A
-Batt A
+Batt B
-Batt B
Console
8
12
11
10
9
7
6
5
4B
3B
2B
1B
1A
Status
2A 3A 4A
ActLn
k
A
ct
Lnk
A
ctLnk
A
ct
Lnk
Stat Stat
Stat S
tat
2
4
6
8
1
3
5
7
Stat Stat Stat
Stat
T1/E1
E
thern
et
-48 VDC
A
ct
Lnk
A
ct
Lnk
A
ct
Lnk
A
ct
Lnk
1
2
4
3