Initializing and Provisioning
7705 SAR-A Chassis Installation Guide 115
Running SSH
After the IP parameters are configured, the CLI can be accessed with an SSH connection. To
establish an SSH connection, run an SSH program and issue the SSH command, followed by
-l and the user name (optional), followed by the IP address.
The following displays an example of an SSH connection with the default admin user:
C:\>ssh -l admin 192.168.1.xx1
TiMOS-B-0.0.I2263 both/hops ALCATEL-LUCENT SAR 7705
Copyright (c) 2000-2014 Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Jul 30 00:11:49 EDT 2014 by csabuild in /rel0.0/I2263/panos/main
admin@192.168.1.xx1’s password: ########
ALU-1#
The default password is admin.
For more information about SSH, refer to the 7705 SAR OS System Management Guide,
“Secure Shell (SSH)”, and the 7705 SAR OS Basic System Configuration Guide. For pinout
information, see Management Port Pinouts.
Telnet Connection
Telnet access via a connection to the management (Mgmt) port provides the same options for
user and administrator access as those available through the Console port or SSH. You can
access the router with a Telnet connection from a PC or workstation connected to the network
once the following conditions are met:
• the router has successfully initialized
• Telnet connections have been enabled using the
config>system>security>telnet-server (or telnet6-server)
command
• the Mgmt port (see Figure 27) has been configured using the bof>address
command (see CLI Syntax below)
CLI Syntax: bof
address ip-prefix/ip-prefix-length [primary |
secondary]
where:
address is an IPv4 or IPv6 address
To Next Page
Loading...
