Alcatel-Lucent 8244 DECT Handset - Installing the Memory Card

Getting started
8AL90396ENAAed01
16 /90
2.3 Installing the memory card
The handset SD card stores handset configuration data and, depending on your system, may also store
subscription data. Please refer to the system administrator for more details.
The SD card allows up to 500 contacts and 200 messages.
You must be in possession of the memory card for your phone.
The supported Micro SD memory cards are:
• Kingston: 2, 4, 8 & 16 GB  Class 4 & 10,
• Trancend 2, 4, 8 & 16 GB  Class 4 & 10.
The SD card must be in FAT format. Please format the SD card if necessary. When installing a SD card for
the first time in the handset (card that has never been used with the handset), it is recommended to use an
empty SD card or one containing only the OPT.bin file. Otherwise, the data on the inserted SD card can be
deleted by the handset.
Switch off the handset.
If the belt clip is installed, you must lift it up and maintain it in this
position during the operation.
Lift up the cover.
Remove the battery from its compartment as shown in the
drawing.
Slide in the memory card from under the two small crescents
and press it as shown in figure.
Position the battery 'connectors ' side as shown in the drawing
(A). Terminate the installation of the battery in its compartment
by pressing as shown in the drawing (B).
A
B
A
B

