Dropping the handset may cause the memory card to dislodge inside the handset. When this happens, the
user will be warned via an audible warning signal every 5 seconds, and the message 'Check memory card'
is given. Please insert the memory card correctly in the handset.
2.4 Charging your telephone battery
The charger is sold separately.
2.4.1 Charging the battery on a single charger
Place the handset into the support facing you, as shown in the picture. Plug the USB cable into the AC/DC
adaptor. Plug the AC/DC adaptor into the mains power supply.
The AC/DC adaptor is not provided with the set. Please contact your provider for a recommended AC/DC
adaptator.
Depending on the configuration of the handset, a beep is emitted when charging begins. The battery status
icon flashes and the LED lights up.
• Green steady: the phone is on the charger and the battery is fully charged.
• Red steady: the phone is on the charger and the battery is charging.
• You can configure how the handset behaves when it is installed on the charger using the settings
menu. Refer to the chapter on configuring your telephone: Adjusting your telephone functions.
To Next Page
Loading...
