Registering the telephone
8AL90396ENAAed01
During registration phase in a multi-system environment, all systems are scanned without priority. The
system is selected when the signal strength is above a certain level and registration matches.
7.2 Registering the telephone on other systems
The telephone can be registered on several systems (maximum of 4).
Note: the input is usually reserved for use with your main Alcatel-Lucent Enterprise system. You can select
the other inputs to register the telephone under another system (Alcatel-Lucent Enterprise or other system).
To make a new registration, when the telephone has already been registered on one or more
systems, proceed as follows:
1. Prepare your system for registration (see the system installation manual or consult your installation
manager).
2. When the system is ready:
• Enter the PIN Code (default code: 0000).
• Apply.
• Enter PARK code (Enter nothing if not mandatory).
• Apply.
• Enter access code (Enter nothing if not mandatory).
• Apply
• Power mode:
Select the power mode using the corresponding softkeys: Normal / 50 mW power (you
are advised not to select the 50 mW power mode unless required. The '50mW power
mode' is intended for hazardous sites such as nuclear plants where it is requested
that emissions do not exceed the maximum value.).
• Enhanced Security
• Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no)
• Select 'Modic' mode:
o Select '8244 Modic' if you connect the handset to an OXO Connect R4.0 and
more, otherwise select '8242 Modic'.
o Select '8242 Modic' if you connect the handset in IP-DECT mode.
• If the registration operation runs correctly (Subscription accepted), the telephone is ready for use, and
the radio coverage icon appears.
• If the registration operation has not been successful, the station proposes launching the subscription
again.
To Next Page
Loading...
