Managing Power over Ethernet (PoE) Power over Ethernet Specifications
OmniSwitch 6560 Hardware Users Guide December 2019 page 4-3
Power over Ethernet Specifications
The table below lists general specifications for Alcatel-Lucent’s Power over Ethernet support. For more
detailed power supply and Power Source Equipment (PSE) specifications, refer to Chapter 3, “Chassis and
Power Supplies.” .
Power over Ethernet Defaults
The following table lists the defaults for PoE configuration:
IEEE Standards supported
IEEE 802.3; 802.af; 802.3at;802.3bt
PoE Class Detection Supported
Range of inline power per port 802.3at ports - 3000-30000 milliwatts
802.3bt ports - 3000-95000 milliwatts
Maximum PoE power per chassis See “Power over Ethernet Budget”.
Parameter
Description
Command(s) Default Value/Comments
PoE operational status lanpower slot service Disabled
Power available to a
port
lanpower power 802.3at ports - 30000 milliwatts
802.3bt ports - 95000 milliwatts
Power available to an
entire slot
lanpower slot maxpower See “Power over Ethernet Budget”.
Power priority level for
a port
lanpower priority low
Capacitor detection
method
lanpower capacitor-detec-
tion
Disabled
Priority disconnect sta-
tus
lanpower slot priority-dis-
connect
Enabled
To Next Page
Loading...
