Alcatel OmniStack LS 6248 - Defining Default Gateways; Figure 3-27. IP Interface Page

Configuring IP Information
81
3
Figure 3-27. IP Interface Page
CLI – The following is an example of the CLI commands for defining an IP interface:
Defining Default Gateways
Packets are forwarded to the default IP when frames are sent to a remote network
via the default gateway. The configured IP address must belong to the same subnet
as one of the IP interfaces. The Default Gateway Page contains parameters for
defining default gateways.
Command Attributes
• User Defined Default Gateway — Defines the default gateway IP address.
• Active Default Gateway — Indicates if the default gateway is active.
• Remove — Removes the default gateway. The possible field values are:
• Checked — Removes the selected default gateway.
• Unchecked — Maintains the default gateway.
Web — Click System, IP Addressing, Default Gateway, define the fields, and specify
a Primary interface, click Apply.
Console(config)# interface vlan 1
4-664
Console(config-if)#
ip address 131.108.1.27 255.255.255.0
4-418