Alcatel OmniStack LS 6248 - Figure 3-107. Protocol Based Groups Page; Mapping Groups to Vlans

Configuring the Switch
216
3
Figure 3-107. Protocol Based Groups Page
CLI – The following is an example of the CLI commands used to create Protocol
Based VLAN groups:
Mapping Groups to VLANs
The classification places the interface into a protocol group.
Command Attributes
• Group Type – Defines the VLAN Group to which interfaces are mapped. The
possible field values are:
• MAC-based – Indicates that interfaces are mapped to MAC based VLAN
groups.
• Subnet-based – Indicates that interfaces are mapped to Subnet based VLAN
groups.
• Protocol-based – Indicates that interfaces are mapped to Protocol based VLAN
groups.
• Interface — Indicates the interface type the VLAN group. The possible field values
are:
• Port — Indicates the specific port added to the VLAN group.
• LAG —Indicates the specific LAG added to the VLAN group.
console(config)# vlan database 4-662
console(config-vlan)# map protocol protocols-group 4-666
console(config-vlan)# switchport general map protocols-group vlan 4-667
console(config-vlan)# show vlan protocols-groups 4-688