Alcatel OmniStack LS 6248 - Active Image; Figure 3-19. Copy Files Page

Configuring the Switch
66
3
or the Backup file will be copied.
• Destination — Specifies the usage for the source file after it is copied. It may be
used as a Starting Configuration file, the Running Configuration file, the Backup
file, or as a configuration file with a new name.
• Restore Configuration Factory Defaults — Resets the Configuration file to the
factory defaults. The factory defaults are reset after the device is reset. When
unselected, the device maintains the current Configuration file.
Web – System, System Management, File Management, Copy Files. Define the
fields. Click Apply.
Figure 3-19. Copy Files Page
CLI – The following is an example of downloading system files using CLI
commands:
Active Image
The Active Image Page allows network managers to select and reset the Image
files. The Active Image file for each unit in a stacking configuration can be
individually selected.
Command Attributes
• Image – Binary file that contains executable code
Console# copy running-config startup-config
4-365
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!! [OK]
Copy took 0:01:11 [hh:mm:ss]